Fagor ADVANCE CONCEPT, Техническое руководство

Страница: 11 / 99

16/11/2012
11
Instructions for the user:
- The exhaust gases may reach high temperatures, therefore exhaust gases and hot plate components
may cause burns.
- Do not place combustible material on top of the appliance. Risk of fire!
- The exhaust gases may reach high temperatures, therefore exhaust gases and hot plate components
may cause burns.
- Do not place combustible material on top of the appliance. Risk of fire!
WATER CONNECTION
WATER CONNECTION WATER CONNECTION
WATER CONNECTION
Only connect drinking water to the appliance.
Connect the appliance to the mains water
supply at point 1, using the hose supplied
como dotación.
Ref Sap 12025198
The pressure of the incoming water should be
between 200 and 400 kPa (2-4 kg/mm
2
). We
recommend 250 kPa.
The water used should have the following properties or characteristics:
PH 6.5÷7.5
Chlorides < 150mg/litre
Chlorine concentration 0.2÷0.5 mg/litre
Conductivity 400÷2000 µS
Water impurities Ø < 0.08 mm
Water hardness 5-10ºF
Recommended filters:
A) Fine filter.
If the water contains impurities such as sand, iron particles or floating substances, we recommend the use
of a fine filter at the water input.
B) Activated carbon filter.
If the water has a high chlorine content over 0.2 mg/l (ppm) (this information can be obtained from the
relevant water board), an activated carbon filter should be installed.
C) Installation of osmosis recirculation.
When the chloride concentration is above 150 mg/l (ppm) (this information can be obtained from the
relevant water board), an osmosis recirculation installation should be mounted. In this case, please
remember that the minimum conductivity value is 400 µS.
D) Water descaling:
For water with a high level of limescale (without chloride load) the water should be treated. Systems: H+.
Interchange of ions or Kleensteam. We strongly advise against the use of sodium exchangers (normally
used in dish washers) due to the formation of sodium sediment and the delay in boiling with common salt.
For the selection of filter systems (A, B, C, D).
Warning
Before connection, look at the label that shows which is the water inlet.
Water intake hose