English
English
Cleaning dispenser units
1
3
2
Cleaning the Filter Holders
All the filter holders should be cleaned at the end of the working day.
Pour 1 litre of cold water and a dose of detergent into a suitable
receptacle.
Remove the filters from the filter holders (
7
).
Leave the filters and filter holders (
7
) in the solution for at least
two hours.
Remove any residues with a sponge and rinse in plenty of cold
water.
Refit the filters in the filter holders (
7
), making sure that the filter
fixing spring is in the correct position.
1.
2.
3.
4.
5.
Drip grid and tray
At the end of the working day, remove the grid from the tray (
10
), pull
out and clean under running water, removing any organic residue.
Drain tray
At the end of the working day, remove the tray (
10
), pull out and
clean under running water, removing any organic residue.
Enclosure
The panels must be cleaned with hot soapy water (not boiling) and
then rinsed with plenty of water, removing any organic residue.
Do not use abrasive cloths or substances since they could damage
the surface of the panels.
N.B.: Do not spray any liquids in the slots.
Water reservoir
Clean the water reservoir at least once a week. Remove the reservoir
and clean under running water, removing any organic residue.
!
Supply Groups
Fasten the filter-holders (
10
) to the groups (without coffee)
Allow the water to flow through for approximately one minute,
pressing one of the coffee buttons repeatedly.
CAUTION
When the machine has not been used for more than 8
hours, and in any case once a day, the internal
components must be washed before use, in
accordance to the following instructions:
!
Hot water
Dispense hot water repeatedly until at least 1 liter of water has
been dispensed.
Steam
Allow the steam to flow through the nozzles for
approximately one minute, using the appropriate commands.
Cleaning dispensing unit
This operation must be made on the group at the end of each
working day
1) Using a brush, clean the cover gasket.
2) Insert the rubber disk into the filter-holder with its filter.
3) Pour in a packet or dosing cupful of detergent powder
4) Attach the filter-holder to the dispenser unit and make a few
coffee cycles.
5) Remove the filter-holder and clean the shower with a sponge.
6) Flush each dispenser unit with water for about 30 seconds.
