fadini APROLI 280 BATT Скачать руководство пользователя страница 4

Страница: 4 / 12

PIC. 3

PIC. 4

PIC. 6

HOW TO FIX APROLI 280 BATT TO A PILLAR BY EXPANDING BOLTS OR SCREWS

Before fitting the operator APROLI 280 BATT to the gate, make sure that the gate structure is adequate to be electrically operated and
that is strong enough to bear the mechanical stress of automatic operations and is well built and smooth running.
It is recommended to reinforce the gate and fix the metallic parts which may not work properly, do the necessary to prevent or correct
friction of the gate against the pavement or pillar (this must particularly apply to the gate hinges).

APROLI 280 BATT is easy to install. It can be supplied either fitted with hydraulic locking device for gates up to 2 m width, or without
hydraulic locking with an electric lock for gate leaf up to 5 m.

The distance from gate pivot center to arm bolt
center is to be calculated through manual
operations of the gate before fixing the shoe
bracket. The distances on page 6-7 are merely
an application example.

Fix the bracket to the pillar and bring the electric cable to the most suitable position so that the fixing of the articulated arm is allowed
to coincide with a solid crossing bar of the gate leaf. The shoe bracket is to be bolted or welded to the gate at a suitable distance which
is set after the first manual tests. (Release lever B page 10)

APPLICATION OF TWO APROLI 280 BATT ON TO A DOUBLE SWINGING GATE.
90

OPENING.

The recommended maximum gate width with APROLI 280 is 5 m. The locking type operator is recommended up to 2 m gate width. Beyond
2 m a lock is required to be fitted to the gate and the non locking type operator is advisable.

Both right-hand and left-hand applications are possible just by turning over the articulated arm and fitting it to the square section shaft
of the operator. Tighten the retaining pin in its seat to fix the arm to the shaft. The assembly ie. motor/jack, fixing bracket and cover are
designed to suit both right and left-hand applications with the same method of installation. Important: the articulated arm must be fixed
so that it pushes against the gates and keeps them well pressed on to the close position gate stop.

It is recommended that suitable gate stops are always fitted to
the system both in open and close gate positions. The gate stop
for open gate position is incorporated with the operator, both
right-hand and left-hand. The gate stop covers are different being
designed as handed units (part No. 2062=right-hand, 2055=left
hand). Another feature of the incorporated open gate stop is the
possibility of being adjusted to the required distance to achieve
the required opening angle, either 90

or more/less.

PIC. 5

VERY LARGE PILLAR
WHERE THE GATE
HINGE IS FIXED
IN THE MIDDLE

4 EXPANDING
BOLTS

MAINS SUPPLY
ELECTRIC CABLE

FIXING
BRACKET

NUTS WITH
WASHER

GATE LEAF

LEVEL

ARTICULATED
ARM

OPERATOR

COVER