background image

1

1. Review the illustrations shown (Figure 1) and select the one

(A, B, or C) that matches your application.

NOTE:

Illustrations shown are for LEFT hand mounting.

RIGHT hand mounting opposite.

FIGURE 1

A

Front of Hood

ABOVE Door Shaft

Bracket

Headplate

Door

Shaft

Front of Hood

BELOW Door Shaft

B

Bracket

Headplate

Door

Shaft

C

Top of Hood

Door

Shaft

Bracket

Headplate

2. Attach the gusset to the bracket using the four 3/8" x 1" cap

screws and hardware shown. Then tighten.

NOTE: 

For Application 1A attach gusset to end of bracket

marked A, etc., (Figure 2).

3. Install the four 3/8" x 1-1/2" cap screws and hardware shown.

Do not tighten.

4. Temporarily locate and clamp bracket in correct position 

on headplate. 

NOTE: 

Leave a minimum of 1" between bracket and headplate

(Figure 3).

5. Place drive sprocket on operator output shaft and driven

sprocket on door shaft. Do not insert keys or tighten set
screws.

6. Hold operator in position on bracket and wrap #50 roller

chain around drive sprocket and driven sprocket to determine
length of chain required.

NOTE: 

Lockwasher and nut will need to be removed and

replaced on operator mounting screws to perform this step.

NOTE: 

Observe location of mounting screws in slots of

bracket. Leave room in slots for chain tensioning. For
Application 1A, screws should be close to bottom of slot with
chain installed, for Application 1B, screws should be close to
top of slot, and for Application 1C, screws should be close to
end of slot towards wall. Readjust bracket if necessary and
repeat procedure before cutting chain.

NOTE: 

Make certain that operator shaft is above, below or in

front of door shaft, never in-line. 7. Remove operator from
bracket and cut #50 chain to required length.

3/8" Flat

Washer

3/8" Split Washer

3/8" Hex Nut

3/8 x 1"
Cap Screw

Bracket

3/8" Flat Washer

3/8" Hex Nut

3/8 x 1-1/2"
Cap Screw

3/8" Split
Washer

Gusset

A

B

C

+

FIGURE 2

Model 1A4324

GJ Hood Mount

Installation

FIGURE 3

Headplate

Top View

1" Minimum

Bracket

Door

Shaft

1

WARNING:

 This product can expose you to chemicals including lead, which are known to the State of California to cause cancer or birth defects or other 

reproductive harm. For more information go to 

www.P65Warnings.ca.gov

Отзывы: