FactoryCat 2023, Руководство пользователя

Страница: 12 / 72

1. TURNING ADJUSTMENT KNOB CLOCK-WISE
(TIGHTENING) WILL RAISE TIPS & LOWER CENTER.
(SEE PICTURE BELOW)
2. THIS SQUEEGEE IS ADJUSTED TOO FAR BACK AND WILL
NOT PICK UP ON THE CORNERS.
*NOTE TIPS OFF THE FLOOR.
(SEE PICTURE BELOW)
3. THIS SQUEEGEE IS ADJUSTED TOO FAR FORWARD
AND WILL NOT PICK UP IN THE CENTER.
*NOTE CENTER SPACED OFF THE FLOOR.
(SEE PICTURE BELOW)
4. THIS SQUEEGEE IS ADJUSTED JUST RIGHT WITH GOOD
DEFLECTION ACROSS THE ENTIRE REAR BLADE
(SEE PICTURE BELOW)
ADJUSTING SQUEEGEE
REPLACING OR ROTATE
SQUEEGEE BLADES
FOR SAFETY : BEFORE LEVEING OR SERVICING
MACHINE STOP ON LEVEL SURFACE, TURN OFF
MACHINE AND REMOVE KEY.
1. REMOVE THE SQUEEGEE ASSEMBLY
FROM THE MACHINE. REMOVE
BLADE RETAINER STRAP AND
REMOVE SQUEEGEE BLADE
2. ROTATE THE SQUEEGEE TO NEW
EDGE POSITION OR REPLACE AS
REQUIRED.
3. INSTALL BLADE ON THE LOCATING
PINS OF SQUEEGEE ASSEMBLY.
4. INSTALL SQUEEGEE RETAINER STRAP.
5. FASTEN AND LOCK KNOBS.
REMOVING SQUEEGEE
1. WITH THE SQUEEGEE IN THE UP POSITION,
TURN MACHINE POWER OFF.
2. DISCONNECT VACUUM HOSE FROM
SQUEEGEE AND LOOSEN BOTH KNOBS.
(SEE PICTURE BELOW)
3. PULL SQUEEGEE ASSEMBLY REARWARD
FROM THE LIFTING CARRIER.
4. INSPECT OR REPAIR AS NEEDED AND REINSTALL.
PAGE 10