FactoryCat 2023, Руководство пользователя

Страница: 16 / 72

PAGE 14
DRAINING SOLUTION TANK
TO DRAIN LEFT OVER CLEANING SOLUTION FROM THE SOLUTION
TANK, PERFORM THE FOLLOWING STEPS.
(SEE FIGURE 18.)
1. PULL THE CLEAR SIGHT TUBE/DRAIN HOSE OFF BARBED ELBOW.
2. RINSE OUT TANK AND SOLUTION FLOW SYSTEM WITH CLEAN
WATER.
FIGURE 18.
ADJUST SOLUTION FLOW
1. TURN SOLUTION VALVE ADJUSTMENT LEVER
(A)
CLOCK-WISE TO INCREASE SOLUTION FLOW,
COUNTER-CLOCKWISE TO DECREASE SOLUTION FLOW.
(SEE FIGURE 15.)
ADJUST SHROUD CURTAIN
1. RELEASE LATCH ON SIDE OF SCRUBDECK SHROUD
TO LOOSEN CURTAIN BANDS.
(SEE FIGURE 16.)
2. RAISE OR LOWER CURTAIN TO DESIRED HEIGHT.
3. RECONNECT LATCH AND SNAP SHUT TO TIGHTEN BANDS.
FIGURE 16.
DRAINING RECOVERY TANK
ALWAYS EMPTY RECOVERY TANK WHEN REFILLING THE SOLUTION
TANK. YOU CAN REFILL THE SOLUTION TANK WHILE THE RECOVERY
TANK IS DRAINING. TO DRAIN THE RECOVERY TANK, PERFORM THE
FOLLWING STEPS.
1. REMOVE DRAIN HOSE FROM THE J-HOOK AND REMOVE THE
CAP.
(SEE FIGURE 19.)
FIGURE 19.
ADJUST "PAD ASSIST" DRIVE
1
. TURN ADJUSTMENT KNOB CLOCK-WISE TO INCREASE DRIVE
SPEED.
(SEE FIGURE 17.)
2. TURN KNOB COUNTER-CLOCKWISE TO DECREASE DRIVE SPEED .
FIGURE 15.
FIGURE 17.
A