BIG ASTOR S.r.l.
FACSIMILE
______________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
Use and maintenance manual
page 8 of 16
INSTALLATION
The machine is supplied completely assembled.
The technology used for the machine makes both its installation and the opening of
the telescopic supports easy and quick thanks to integrated springs and a system of
mechanical know-how developed specifically for this type of use.
PROCEDURE
1) Place the machine on the ground on one of its longer sides in order to have a 90°
angle with the ground.
2) Open the telescopic supports one by one keeping your hand as close as possible to
part n° 2 shown in the picture in order to facilitate its withdrawal from part n° 1.
3) Push the telescopic support towards part n° 3 tightening the spring.
4) Open the telescopic support by rotating it by 90° and let part n° 2 reposition again
in part n° 1.
5) Follow the same procedure to fix the other telescopic supports.
6) Build up all the telescopic supports (consisting of a tube of a smaller diameter
inserted in that of a larger diameter): Phase a) Rotate the tube of a smaller
diameter towards the sticker aperto-open till the end. Phase b) pull out the tube till
it reaches the standard size of 2050 mm marked by a hole in the tube. Phase c)
Rotate the tube again in the opposite direction towards the sign chiuso-closed till
the end; this way the sliding of the tube will be blocked.
7) Lift the machine making the four telescopic supports touch the ground.
8) If necessary, adjust the height of the four supports trying to keep the cover surface
as horizontal as possible (follow the procedure in point 6).
9) To close the machine after its use, follow the above-mentioned procedure in the
opposite order.
After the machine has been placed on the site, it does not need any further
adjustments or controls, except making sure that the blocking device of the
telescopic supports is actually in the blocked position.
(see point 6, phase 3, chapter installation).
