FABtotum Personal Fabricator, Руководство пользователя

Страница: 60 / 123

FABtotum Complete Manual
www.fabtotum.com
| 60
Load the material_test_pattern.GCODE gcode file from the Make>Laser menu.
Proceed to put on your safety goggles and take note of the safety warnings and hazards that are listed before starting.
Calibrate the Z using either manual positioning or assisted positioning.
Now get yourself a normal 80gr piece of white printer paper, and place it on the build area (Milling side up).
If you use manual positioning you already know the heigth or perhaps you are using the last known position in a series of
laser jobs, all at the same height.In the case of assisted positioning you will be asked to manually move the part you want
to laser at around 1 mm from the lower tip of the Laser Head.
Then, after pressing ok , the height will be raised automatically to match the last saved position (3 mm if this is your first
time calibrating).
The engraving will start and end within a minute.
Once the process has completed a series of patterns like these should be engraved on the piece of paper.
Find and save the position
What you need to see is:
A perfect rectangle, almost cut off. 1.
A sequence of numbers from 1 to 10 2.
A series of “gradient” lines that starts with 50% horizontal fill on the first line (1) and ends with a full black mark 3.
-100% fill – on the last line (10)