FABtotum Personal Fabricator, Руководство пользователя

Страница: 42 / 123

FABtotum Complete Manual
www.fabtotum.com
| 42
Depending on the model of the FABtotum (Core, Pro editions) the filament is loaded and unloaded in a different manner.
It’s important to notice that since the Printing Head PRO does not require the feeder mechanism to work, the filament will
not be inserted in the feeding mechanism but in a different loading hole.With the printing head PRO you can automatically
unload or load a spool: From the Maintenance menu, go to Spool.
Such option is also available during a print if the print is paused.
You can also load and unload manually the filament by using the filament release lever on the back of theprinting head Pro
if the nozzle temperature is over 170°C and the unit is not performing any task.
As usual, make sure the filament entering the head is straight and pointy (cut the tip with scissors at an angle).
Core
The CORE edition of the FABtotum Personal fabricator have a secondary hole in the spool compartment where to insert
the filament if the print head pro is installed. It is marked by a label in the upper rear corner of the spool compartment.
Use this hole to insert the filament up to the head.
Install the PTFE tube on the Print Head PRO (1,2) and the back of the FABtotum CORE.
Do not use the onboard feeder mechanism to feed the print head PRO.
Push the filament up until the print head PRO feeding gear, then pull the lever in the back pof the print head pro to
complete insertion by pushing the filament further(3).
Core PRO
The CORE PRO edition of the FABtotum Personal fabricator have a secondary hole in the spool compartment where to
insert the filament if the print head pro is installed. It is marked by a label in the upper rear corner of the spool
compartment.