14. Locate the flange at rear of the pipe just cut. Remove
mounting bolts at the flange and discard this section of
Exhaust pipe.
SEE FIGURE 17.
15. Locate the replacement Exhaust Tube, Clamp and
Hardware. Install the slip tube section onto the cut pipe
with the Clamp or have muffler shop build and install new
pipe after suspension installation.
SEE FIGURE 18.
11. Once gusset kit has completely cooled, paint all bare
metal areas.
SEE FIGURE 14.
12. Remove the front upper & lower link arms and save the
factory hardware (upper link arm bolt on the passenger
side will need to be cut to be removed).
If you are installing the FTS94060 loop delete pipe for
2012-13 models complete steps 13-16 now.
13. Locate the section of exhaust after the catalytic converter
near the front driver side upper link arm pocket.
Measuring 2”back from the weld at the cat, mark and cut
the pipe.
SEE FIGURE 15-16.
FIGURE 15
FIGURE 16
FIGURE 17
FIGURE 18
8 of 31
FIGURE 14
TRAC BAR SHOWN INSTALLED (FOR PHOTO ONLY)
