38. Remove the factory coil springs, and discard, you will
need to allow the axle to hang freely to remove the coil
springs. Remove the factory upper coil isolator and save.
39. Support the axle with 2 floor jacks or large ratchet
straps, remove the upper & lower link arms and save the
hardware.
36. Remove the factory shocks and discard, save the
hardware. Remove the rear sway bar end links and save
with the hardware.
SEE FIGURE 66.
37. Remove the brake line brackets from the frame and save
the hardware. Remove the plastic clips that hold the ABS
lines to the frame and at the rear upper link arm pockets.
Do not damage the clips, they will be reused. Remove the
top differential cover bolt and remove the ABS line clamp.
Save the bolt. Remove the two nuts holding the E-Brake
cable to the bottom of the body and save.
SEE FIGURES 67-69.
FIGURE 66
FIGURE 67
FIGURE 68
FIGURE 69
18 of 31
