For technical assistance call: 909-597-7800 or e-mail: [email protected]
Read this before you begin installation-
Check all parts to the parts list above before beginning installation. If any parts are missing contact Fabtech at 909-597-7800
and a replacement part will be sent to you immediately.
Read all instructions thoroughly from start to finish before beginning the installation. If these instructions are not properly
followed severe frame, driveline and / or suspension damage may occur.
Check your local city and state laws prior to the installation of this system for legality. Do not install if not legal in your area.
Prior to the installation of this suspension system perform a front end alignment and record. Do not install this system if the
vehicle alignment is not within factory specifications. Check for frame and suspension damage prior to installation.
The installation of this suspension system should be performed by two professional mechanics.
Use the provided thread locking compound on all hardware.
Do not combine this suspension system with any other lift device or parts.
This suspension must be installed with Fabtech shock absorbers.
WARNING- Installation of this system will alter the center of gravity of the vehicle and may increase roll over as compared
to stock.
On EcoBoost 3.5L and 2.7L models, discard all air shields.
OEM Wheels and tires cannot be used after the installation of this kit. Larger tires cannot be installed on the OEM wheels.
Verify differential fluid is at manufacture’s recommended level prior to kit installation. Installation of the kit will reposition the
differential and the fill plug hole may be in a different position. (For example, if the manufacture recommends 3 quarts of fluid,
make sure the diff has 3 quarts of fluid). Check your specific manual for correct amount of fluid.
Recommend Tires and Wheels:
Use 35/13.50R18 tires w/ 18x9 wheels w/ 5” BS w/ minor trimming
Use 35/13.50R20 tires w/ 20x9 wheels w/ 5” BS w/ minor trimming
Use 285/55R22 tires w/ 22x9.5 wheels w/ 5” BS w/ minor trimming
- PRE-INSTALLATION NOTES -
3 of 16
Prior to installing this kit, with the vehicle on level
ground. Measure the height of your vehicle. This
measurement can be recorded from the center
of the wheel, straight up to the top of the inner
fender lip. Record the measurements below.
LF:______________________
RF:_______________________
LR:______________________
RR:_______________________
Required Tools (Not Included)
Floor Jack Jack Stands Torque Wrench
Assorted Metric and S.A.E sockets, and Allen wrenches
Die Grinder w/Cut-off Wheel Torque Wrench
1-1/2” Barrel Sand Wheel 1/2” Barrel Sand Wheel
- TOOL LIST -
