Faber INHC29SSV, Инструкции по установке; Информация по использованию и уходу, Страница: 26 / 56

26
1
2
3.a
EN
77
INSTALLATION
Fitting the Hood canopy
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
• Disconnect the wires to the Commands at the connectors.
• Disconnect the wires to the Light at the con-
nectors.
• The Hood can be installed directly on the
underside of the wall unit (Minimum 650 mm
from the Cooker Hob).
• Create an opening in the bottom of the wall unit,
as shown.
• Insert the hood until the side supports snap into
place.
• Fasten using the 10 screws 12a provided.
• Lock in position by tightening the screws
Vf
from
underneath the hood.
• Open the suction panel by turning the specific knob.
• Disconnect the panel from the hood canopy by sliding the
fixing pin lever.
• Remove grease filters.
• Screw the Frame into place
using the 6 screws
12f
, re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
260
13
495 - 675
Pratiquez
l'ouverture
sur la face
inféri-
eure de
l'armoire,
comme il-
lustré à la
Figure 1.
Notice d'installation
Retirez les trois filtres de la hotte
encastrable avant de l'installer
dans l'armoire.
Installation avec canalisation verticale
Installez le clapet de
toiture ou le clapet mural
acheté séparément.
Raccordez le conduit
métallique de 6" au clapet
de toiture ou au clapet
mural, puis raccordez les
conduits.
Hotte 29" 35"
X 27 5/8" 33 3/4"
Y 13 9/16" 13 9/16"
0LQ
´
´
´
´
X
Y