Installation Instructions
VI-COWL
Product Number: VC2900
2010 - 2018 DODGE 2500
Copyright 2009 Fab Fours, Inc
. Page 13 of 19
VC2900_Installation_Manual_REV_A
e.
After the hood looks aligned, fully tighten down the four factory bolts on
the lower hinge brackets by means of reaching up under the fender in the
wheel well.
f.
Slowly raise the hood just enough to reach in with a ratchet and fully
tighten down the four factory bolts securing the hood.
g.
Raise the hood fully and reconnect the gas assist springs on the ball joint
on the hinge upper arm.
Note: be mindful of how high you raise the hood while making adjustments to
alignment. It is possible that the hood will shift without your knowledge if hood is
raised too high.
VII.
ViCowl Pre-Assembly
Note: It’s highly recommended that all projection weld nuts are chased with the
appropriate taps to clean out any powder coat or foreign debris prior to assembly.
Tap sizes needed to do this are ½”-13, and ⅜"-16
Fig 10
