XKP W
7
532110 - Rev.A
Ch4
Ch2 Ch3
Ch1
LED
verde/rosso
green/red
rouge/vert
rot/grün
rojo/verde
rood/groen
3.8
TEACH THE RADIO CODE
TEACH A RADIO RECEIVER
When the XKP W is waiting for an operation, enter:
8 # Ch
25 s
E.g. transmit the Ch 1 radio code: 8 # 1
Place the receiver in learning mode on the required radio channel within 25 s (follow the receiver’s
instructions and maintain the recommended distance between the devices), then press:
#
(keep it pressed until confirmation is given that the code has been learnt, then release it)
60 s
The code of the radio channel entered is transmitted (Green LED on). Make sure that the receiver confirms
that the code has been learnt (receiver's instructions).
Repeat the procedure for each radio channel required. When using the XKP W for the first time, each
radio channel has to be activated twice in succession:
Easy Operation
enter:
user code E wait until the Green LED turns off, then press E
Advanced Operation
enter:
# user code E Ch. wait until the green LED turns off, then repeat Ch.
Teach the radio code
. This allows a
master
XKP W
to ‘teach’ the radio code of a channel to
a target device.
This procedure must be carried out for each radio
channel that you wish to use.
Only the master XKP W devices can teach the
codes.
-
If the XKP W is installed on a new radio system, it
must teach it to a Radio Receiver.
-
If the XKP W is already being used on the radio
receiver and you wish to add a radio transmitter,
the target device can be a radio control or an
additional Master or Slave XKP W.
Follow the procedures indicated below according
to the target device.
