XKP W
3
532110 - Rev.A
Ch4
Ch2 Ch3
Ch1
LED
verde/rosso
green/red
vert/rouge
rot/grün
rojo/verde
rood/groen
2. INSTALLATION
!
The surface on which it is to be installed must
be flat and smooth. The IP sealing gaskets
must be present and intact, in the base
(
1
) and in the body (
3
).
1.
Insert the batteries. Insert the batteries the
correct way round and follow the instructions
in
1
.
-
The XKP W lights up for 1 s and then goes into
standby: The signalling LEDs and backlighting
are off.
2.
Assemble the body and base temporarily.
3.
The XKP W has to be stored on the radio receiver:
- On a new system, the XKP W has to teach the radio
code to the receiver SLH (§ 3.8).
- If the XKP W is added to an existing system, the
XKP W must learn the radio code from a SLH trans-
mitter that has already been programmed (§ 3.9).
4.
If you wish to change the Easy/Advanced operat-
ing mode, carry out the procedure indicated in §
3.12 before storing the user codes.
5.
The user codes must be stored on the required
radio channels (§ 3.1).
6.
Carry out any optional programming such as
button E (§ 3.6) and the Slave XKP W (§ 3.10).
-
We recommend that you change the PWD (§ 3.4).
7.
Check that all the user codes work correctly on
all the enabled radio channels. Check that the E
button is working properly, if enabled.
8.
Install the base. Follow the instructions in
2
.
9.
Secure the body to the base (
3
). Use fasten-
ers suitable for the material to which it is to be
attached and keep to the screw dimensions
indicated in the figure for wood / brick / masonry
(
A
) or metal (
B
).
10.
Fully tighten the screws in order to compress the
IP sealing gaskets.
11.
Secure the cover (
4
).
Note
Always press one button at a time (if 2
buttons are pressed at the same time, neither is
recognised). The timeout between the pressing
of buttons is 5 s. Each time a button is pressed,
the XKP W issues a short acoustic signal and the
backlighting turns off momentarily.
Key to Symbols
LED off
LED on
Flashing
Fast flashing
Time
Beep
Signal on XKP W
OK
1
0.5 s (green)
ERROR
5
5
(red)
TIMEOUT
waiting for operation
60 s (red)
STANDBY
(green and red)
