XFS
3
532305 - Rev.A
Tr
ansla
tion of the original instruc
tions
ENGLISH
TECHNICAL SPECIFICATIONS
Power supply
from BUS 2easy connection, with
two 24V non-polarised wires
Absorption (mA)
10
Max. range (m)
15
Protection class
IP54
Obstacle detection time
20 ms
Alignment
Automatic
Self-alignment angle
±7° (15m)
±13° (5m)
Operating ambient temperature
-20°C
+55°C
Installation
Wall-mounted
Dimensions
See Fig. 1
INSTALLATION
!
These photocells can only be used with FAAC
equipment featuring a BUS 2easy technology.
A max. of 16 pairs of photocells can be connected
on each system.
The receiver and the transmitter must be aligned.
To set the operating mode of the photocells, refer to
the instructions of the control unit.
Two installation types are possible:
With recessed tube, Fig. 2.
With external tube or external sheath, Fig. 3.
In both cases operate as follows:
-
Prepare the electrical connections.
-
Secure the housings by means of suitable fastening
systems.
-
The connection wires must be routed through the
supplied cable gland (Fig. 2 and 3 ref.
햲
).
CONNECTIONS
The BUS connection is formed by two non-polarised
conductors
-
Connect the photocells as shown in Fig. 4.
-
For the connection to the control board refer to
the specific instructions.
START-UP
-
The dip-switch DS1, which is located on the boards,
determines the behaviour and the address of the
photocell pairs.
-
For a correct set-up of the dip-switches, refer to
the instructions of the control unit.
-
Each pair of photocells must have the same setting.
-
Power up the system and check the behaviour of
DL2 LED according to the table below:
Status
Description
Steady light
Correct operations
Flashing
Incorrect BUS connection
OFF
Does not operate/disconnected
-
Check LED DL1 for the correct alignment of the
photocells:
Status
Description
ON
Correct alignment
OFF
Incorrect alignment
DECLARATION OF CONFORMITY
Manufacturer:
FAAC S.p.A. Soc. Unipersonale
Address:
Via Calari, 10 - 40069 Zola Predosa BOLOGNA - ITALY
Declares that:
The optoelectronic protection device mod.
XFS
complies with the following applicable EU legislations:
2014/35/EU
2014/30/EU
2011/65/EU
Furthermore, the following harmonised standards have been
applied:
EN 60335-1:2012 + A11:2014
EN 61000-6-2:2005
EN 61000-6-3:2007 + A1:2011
Bologna, 01 April 2019
CEO
A.
Marcellan
GUIDE FOR THE INSTALLER
Содержание XFS
Страница 1: ...XFS...
Страница 10: ...XFS 8 532305 Rev A...
