6
75
67
63
ENGLISH
3.3 LT WIDTH BETWEEN 136 and 180 cm
For assemblies with an LT (Fig. 3-5) length between 180 cm
(maximum)
and 136 cm
(minimum)
, use
the motor and cap sleeves
(Fig.1 ref
-
) and the fixed roller. (Fig.1 ref.
).
To obtain the minimum value, fully insert the 2 sleeves (Fig.10 ref. A-C) inside the fixed roller (fig.10 ref.B ). (Roller length 130cm)
To obtain the maximum value, withdraw the 2 sleeves (Fig.10 ref. A-C) from the roller, up to the safety limit marked on the plate
(Fig.10 ref.D). (Roller length 175cm)
SLIDING
SLIDING
Motor sleeve
(A)
Safety limit
(D)
Fixed roller
(B)
Cap sleeve
(C)
Fig. 10
4
INSTALLING THE CAP
The cap (Fig.1 ref.
) must be installed directly on the fixed roller (Fig.1 ref.
). See figure11
4.1 ASSEMBLIES DESCRIBED IN CHAPTERS 3.1 AND 3.2 (Fig. 8-9)
4.2 ASSEMBLIES DESCRIBED IN CHAPTERS 3.3 (Fig. 10)
The cap (Fig.1 ref.
) must be installed directly on the cap sleeve (Fig.1 ref.
). See figure12
Fig. 12
Fig. 11
WHEN YOU SLIDE THE SLEEVES TOWARD THE OUTER ENDS OF THE FIXED ROLLER, NEVER GO BEYOND THE SAFETY
LIMITS (Fig.10 ref.D)
According to the type of assembly previously carried out on the electro-roller, as described in chapter 3, follow the instructions in
the paragraphs below.
IMPORTANT: USE A RUBBER HAMMER TO INSTALL THE CAP. (Fig. 11-12)
130 MIN
175 MAX
