![background image](http://html.mh-extra.com/html/flair21/vertical-wrap/vertical-wrap_installation-instructions_2302137001.webp)
flair21.com | 800.845.0918
OVER
Your Vertical Wrap system has been custom made to your specifications. The appropriate mounting hardware
(either ceiling or wall clips) is included as per your order.
PLEASE FOLLOW THESE INSTALLATION INSTRUCTIONS.
You will need a pencil, tape measure, drill, screw driver, pair of pliers, and the appropriate fasteners.
VERTICAL WRAP
i n s t a l l a t i o n i n s t r u c t i o n s
Step 1
OUTSIDE MOUNT
Find the height for the top of the
bracket (as measured from the floor)
by adding the desired clearance to the
overall height of the treatment. When
installed, the recommended clearance
from the floor is
1
⁄
2
”.
Place the first bracket directly over the corner of the
window with a maximum of 15” between brackets.
Adjust the length of the bracket so that the louvers
clear any obstructions.
Step 1
INSIDE / CEILING MOUNT
Mount the clip bracket directly into the
ceiling or head. If installing a valance, that
clip must also be installed at this time.
The center of the clip bracket is also the
center of the vane hook. Therefore, mount the
screw a minimum of 2
1
⁄
4
” in front of the window
frame (or other obstruction) to allow clearance
for the vanes. The maximum distance between
clips should be 15”.
Step 2
INSTALL HEADRAIL
After mounting all brackets, snap
in the headrail as illustrated. To
remove the headrail, simply push
the release lip up with a screwdriver.
Step 3
ATTACH VANES
Push the vane into the top of the hook, then
pull straight down to ensure it locks into place.
Step 4
ATTACH TENSION DEVICE
Attach the child safety device to its mounting bracket. Pull down on the bracket to align the center of the
screw hole with the indicator line. Mark and pre-drill the screw holes. Pull down on the bracket and device,
align it with the drilled holes, and mount the bracket. Check to ensure the loop can move freely through
the device.
Indicator Line
Outside Mount
Screw Hole
Inside Mount
Screw Hole
Step 5
TEST TRAVERSE
Alternately pull the cords to see that
the blind traverses smoothly in both
directions.
CAUTION: ONLY TRAVERSE THE
BLIND WITH THE VANES IN THE
OPEN POSITION!
Step 6
TEST ROTATION
Pull the beaded chain once in each
direction, to completely rotate the
vanes from open to closed. This will
automatically align all of the vanes.