7
ENGLISH
A
B
C
A
B
C
5
INSTALLATION OF SUPPORTS SUPPLIED WITH THE KIT
5.1 SUPPORTS WITH BRACKETS FOR WALL FITTING
Fig. 13
Secure the adjustable motor support (Ref. A) in the hole of the wall fitted
bracket. (Ref. B), as shown in figure 13
Secure the motor support on the plates C (Fig.1 ref.
), using the bolts/nuts/M5
washers (Fig.1 ref.
!
)
For adjusting the support height and for securing the plates, see chapter 6
1.
2.
3.
5.2 SUPPORT WITH SQUARE TO BE SCREWED
Secure the square support (Rif.B) to the wall, using the wall expansion plugs.
(Fig.1 ref.
!
)
Secure the adjustable motor support (Fig.14 ref. A) in the hole of the square
(Ref. B), as shown in figure 14
Secure the motor support on the plates C (Fig.1 ref.
), using the bolts/nuts/M5
washers (Fig.1 ref.
!
)
For adjusting the support height and for securing the plates, see chapter 6
1.
2.
3.
4.
If the wall fitting bracket is not present, you may use the square to be screwed (Fig.1
ref.
):
Fig. 14
6
INSTALLING THE ELECTRO-ROLLER IN THE BOX
After you have correctly installed the supports, as described in chapter 5, install the assembled electro-roller in the box:
Fit the motor head on the rapid fitting on the motor support (Fig.16 ref.A). The motor must be oriented to enable access to the
adjustment screws of the limit switches (Fig.16 ref. B).
Allow the telescopic components of the electro-roller to slide until the cap is inserted on the bearing in its support (Fig.16 ref.C).
Check if the roller is positioned perfectly horizontally, if necessary modifying the heights of the supports (Fig.16 ref.A-C), with the
nut-locknut system.
Secure the plates of the motor support on the wall (Fig.13-14 Ref.C) using the expansion plugs (Fig.1 ref.
!
).
Near the guide holes on the plates (Fig.16 ref.D), drill a hole with a 5mm diam. bit suitable for iron.
In the holes (Fig.16 ref.D), screw the supplied self-tapping screws (Fig.1 Ref.
!
), firmly securing the roller components to each
other.
1.
2.
3.
4.
5.
6.
5.3 CAP SUPPORT
If it is necessary to install the cap support supplied with the kit
(Fig.1 ref.
), refer to the instructions in paragraphs 5.1 and 5.2.
The installation procedure is the same as for the motor support,
with only one exception: the plates are not used.
Fig. 15
Cap support
NOTE: The electro-roller can be installed with the motor sleeve part oriented to right or left.
