FAAC T-MODE TM 35 ER, Руководство пользователя

Страница: 8 / 26

X 1
ENGLISH
8
BEFORE COMPLETING THE SET-UP, THE MOTOR COULD ROTATE IN THE OPPOSITE DIRECTION TO THE GIVEN COMMAND (E.G. YOU
PRESS THE UP PUSH-BUTTON AND THE ROLLING SHUTTER LOWERS); AT THE END OF THE SET-UP, THE UP AND DOWN PUSH-BUTTONS
ARE AUTOMATICALLY MATCHED TO THE CORRECT DIRECTION OF ROTATION.
ALWAYS HELD DOWN
UNTIL CONFIRMATION BY THE MOTOR
OR
5.2.2 AUTOMATIC SET-UP FOR ROLLING SHUTTERS WITH MANUAL SETTING OF THE DOWN TRAVEL LIMIT
( Only for rolling shutters with opening mechanical stops)
WHEN THE AUTOMATIC SET-UP IS PERFORMED, THE MOTOR SETS IN THE ROLLING SHUTTER MODE.
Fig.11
1) Press and hold down the up push-button;
2) The rolling shutter rises and searches for the up mechanical stop point; then after a few seconds it starts to lower and
stops at the lower mechanical stop point.
3) After the motor has performed 2 brief movements (one in one direction and one in the other direction), release the
push-button.
4) By controlling the rolling shutter rise and lowering, check the correct setting of both travel limits.
5) If the travel limits have not been set correctly, execute a reset (chapter 6) and repeat the automatic, semiautomatic
or manual set-up procedure.
FIND THE PUSH-BUTTON CONTROLLING THE RISE AND HOLD IT DOWN UNTIL THE MOTOR
ROTATES IN BOTH DIRECTIONS (END OF SET-UP)
BEFORE COMPLETING THE SET-UP, THE MOTOR COULD ROTATE IN THE OPPOSITE DIRECTION TO THE GIVEN COMMAND (E.G. YOU
PRESS THE UP PUSH-BUTTON AND THE ROLLING SHUTTER LOWERS); AT THE END OF THE SET-UP, THE UP AND DOWN PUSH-BUTTONS
ARE AUTOMATICALLY MATCHED TO THE CORRECT DIRECTION OF ROTATION.
If the mechanical sensor for obstacle detection has not been fitted, you can perform the “automatic” set-up and
set the down travel limit in manual mode. Up mechanical stops MUST BE AVAILABLE to set the up travel limit.
1) Press and hold down the push-button controlling the rolling shutter rise;
2) The rolling shutter rises and searches for the upper mechanical stop, then it starts to lower.
( Do not release the push-button )
3) Release the push-button where the down travel limit is to be set (Adjustment is possible by means of the up/down
push-buttons)
4) Press the STOP/PREFERRED POSITION push-button until the motor performs 1 brief movement in both directions.
5) By controlling the rolling shutter rise and lowering, check the correct setting of both travel limits.
6) If the travel limits have not been set correctly, execute a reset and repeat the set-up procedure.