FAAC T-MODE TM 35 ER, Руководство пользователя

Страница: 4 / 26

a
c b
A
a
A = ..x.. mm
A = ..x.. mm
Ø 3 mm
b
b
4X10
a
c
b
a
b
ENGLISH
4
MODEL
T-MODE
58 ER
TORQUE
(Nm)
FREQUENCY
OF USE
MAX.
TIME
OF USE
(min.)
SPEED
(Rpm)
VOLTAGE
(V)
FREQUENCY
(Hz)
POWER
(W)
CURRENT
(A)
MOTOR
SHAFT MAX.
ROTATIONS
MOTOR
DIAMETER
(mm)
“L” LENGTH WITH
ADAPTER
(mm)
PROTECTION
CLASS
70/12 70 20% 4 12 230 50 310 1.4 50 45 540 IP44
80/12 80 20% 4 12 230 50 320 1.5 50 45 540 IP44
100/12 100 20% 4 13 230 50 410 1.9 50 45 550 IP44
120/12 120 20% 4 13 230 50 450 2.1 50 45 550 IP44
Fig. 2
Fig. 3
Fig. 4
Fig. 5
3 INSTALLATION
3.1 ASSEMBLING THE TUBULAR MOTOR
1) Fit the crown adapter (Fig.2 ref.
a
) in the tubular motor,
until it is completely inserted in the guide on the travel
limit ring nut.
2) Fit the wheel adapter (Fig.2 ref.
b
) in the motor shaft. If,
in the application for rolling shutters, the obstacle detection
during lowering is required, fit the mechanical sensor for
obstacle detection before fitting the wheel adapter (fig.2
ref.
b
A). (already built-in in model TM35 ERO)
3) Lock the adapter with the supplied stop. (Fig.2 ref.
c
)
4) Make sure that the adapter is well secured (Fig.2 ref.
c
)
3.2 INSTALLING THE TUBULAR MOTOR
1) Measure dimension A on the tubular motor, as shown
in figure 3 ref.
a
.
2) Drill a hole with a drill Ø 3 mm on the roller (Fig.3 ref.
b
) at the distance A, previously measured on the tubular
motor (Fig.3 ref.
a
).
3) Fit the assembled tubular motor inside the roller from
the side opposite the cap, until the crown adapter is
completely inside the roller (Fig.4 ref.
a
).
4) Secure the wheel adapter to the roller with a tapping
screw 4x10 fitted in the previously drilled hole, as shown
in figure 4 ref.
b
.
5) Install the previously chosen motor support from the side
of the electric facility (Fig 5 ref
a
).
6) Fit the motor-driven roller in the motor support (Fig.5 ref.
b
), and on the cap support (Fig.5 ref.
c
).
7) Check with a level if the motor-driven roller is perfectly
horizontal; if necessary, modify the height of the motor or
cap supports.
ELECTRIC FACILITY SIDE