6
a
ENGLISH
Close the gate leaf and install the front fitting on the rod as
shown in Fig. 11 re.
b
.
Establish the fixing position of the front fitting on the leaf
and mark the fixing points (Fig. 12)
(the operator must be
perfectly level).
Disassemble the operator from the front fixing to avoid
damaging the rod when the front fixing is installed on the
gate.
Weld the front fixing directly on the leaf or screw it by means
of threaded inserts.
If an opening mechanical stop on ground is not installed,
spacers can be used (Fig. 1 re.
g
). Remove the front
articulated joint and insert on the rod the number of spacers
required to reach the desired opening angle (Fig. 14).
10.
11.
12.
13.
14.
If an external mechanical
stop
point at closure is pre-
sent, remove the rod comple-
tely and then insert it 5 mm.
Fig. 12
Fig. 13
Fig. 15
Fig. 16
MINIMUM
BENDING
RADIUS
60 mm
MINIMUM
BENDING
RADIUS
60 mm
Fig. 17
Fig. 14
Secure the operator to the front fixing (Fig. 15).
Remove the bleed screw (Fig.16 ref.
a
) paying special
attention to leave the sealing O-Ring in its seat
Install the metallic protection cover as shown in Fig. 16, insert
and tighten both tie-rods
Connect the cable to the operator using the two screws
supplied, as shown in Fig. 17.
15.
16.
17.
18.
Содержание S450H
Страница 1: ...S450H...
