ND1
24
732558 - Rev. D
N L
P
B
A
230 Vac
50-60Hz
Red or Black
Ear
th
Blue or gr
ey
Br
o
w
n
PUSHBUTTON
Connect the yellow green cable to earth.
Connect the brown and blue (or grey) cables to 230V.
AUTOMATION COMMANDED ONLY BY REMOTE CONTROL: If you wish to perform this type of confi guration, you must connect the blue
wire and the brown wire of the engine to the mains power supply and the yellow-green wire to earth. The RED or BLACK wire must not
be connected.
AUTOMATION COMMANDED BOTH BY REMOTE CONTROL AND BY PUSHBUTTON: If you wish to use this type of confi guration, connect
the engine according to the diagram in fi gure 36.
The button has step logic: every time the button is pressed a pulse is sent to the engine (EXAMPLE: FIRST OPEN PULSE-SEC-
OND STOP PULSE-THIRD CLOSING PULSE-etc.). After an opening or closing command, the engine is active up to the limit switch.
The N1D SENSO can be either remote controlled or controlled by a
step logic button and automatically inverts the motion as soon as
it encounters an obstacle.
11.3 Electric wiring mod. N1D SENSO KIT
Fig. 36
Every time the open or close button is pressed on the remote control, it commands a complete movement. Press the STOP pushbutton
to stop the manoeuvre.
11.4 Remote Control mod. N1D SENSO KIT
Fig.37
OPENING
CLOSING
STOP
PROGRAMMING
KEY
11.5 Storing the fi rst remote control mod. N1D SENSO KIT
1) Power the engine.
2) After a few seconds, the engine performs a brief movement in both directions to indicate the absence of stored remote controls.
3) Press the programming key "P" for 2 seconds within 10 seconds and then the "STOP" key (see the fi gure).
4) The engine performs 2 brief movements in both directions to indicate that the remote control has been stored.
The remote control inside the KIT is already stored inside the engine. This procedure, therefore, does not need to be
performed.
Содержание N1D AUTO KIT
Страница 1: ...N1D KIT N1D AUTO KIT N1D SENSO KIT ...