Fig. 11
Fig. 12
10 mm
16 mm
+
+
11 AUTOMATED SYSTEM TEST
When you have finished programming, check if the system is
operating correctly. In particular, check if the safety devices
are operating correctly.
9.3.1 REMOTE MEMORY STORAGE OF LC RADIO
CONTROLS
Other radio controls can be remotely stored only with the
LC radio controls, i.e. without using the LOGIC-SPEED-SETUP
push-buttons, but using a previously stored radio control.
Get a radio control already stored on one of the 2 channels
(OPEN A or OPEN B ).
Press and hold down push-buttons P1 and P2 simultaneously
until both the LEDs flash slowly for 5 sec.
Within 5 sec. press the push-button of the radio control
that had been memory stored to enable learning on the
selected channel.
The LED on the board relating to the channel being learned
flashes for 5 sec., within which time the code of another
radio control must be transmitted.
The LED lights up on steady beam for 2 seconds, indicating
memory storage executed, and then resumes flashing for
5 sec., during which other radio controls can be memory
stored, and then goes OFF.
9.4 RADIO CONTROLS DELETION PROCEDURE
To delete
ALL
the input radio control codes, press
push-button LOGIC (SW3) or SPEED (SW2) and, while holding it
down, also press push-button SETUP (SW1) for 10 sec.
The LED relating to the pressed push-button flashes for
the first 5 sec, and then flashes more quickly for the next
5 sec.
Both LEDs light up on steady beam for 2 sec and then go
OFF (deletion completed).
Release both push-buttons.
This operation is NOT reversible. All codes of
radio controls stored as OPEN A and OPEN B will
be deleted.
1.
2.
3.
4.
5.
1.
2.
3.
10 CONNECTION OF BUFFER BATTERIES (OPTIONAL)
The buffer battery kits will activate the automated system also
in the event of a power cut.
For correct positioning, observe the following instructions.
The batteries come into operation when a mains
power cut occurs.
10.1 BATTERY KIT
The buffer battery kit was built for insertion inside the control
board support.
This support (Fig.11 ref.
) was pre-moulded to permit the
battery housing to be opened.
Remove the board support material covering the
battery housing, cutting the material connections along
the perimeter.
1.
Insert the battery in the housing you have just created, and
secure it on the anchoring supports (Fig.12).
2.
To correctly fasten and connect the kit to the control
unit, consult the instructions enclosed with the
battery kit.
3.
ENGLISH
9
Содержание E700
Страница 1: ...E 700 E 700...
