FAAC E604, Руководство для установщика

Страница: 15 / 60

E604
ENGLISH
Guide for the installer
Pagina 11
1. DESCRIPTION
Thank you for choosing our product. FAAC is sure that it will give you all the performances you are looking for. All our products are the
result of a long experience in the field of the automated systems.
Thanks to its high powered microprocessor, this 24 V control unit for automatic barriers offers a wide range of adjustments, including
deceleration and motor control.
Thanks to its integrated encoder, the control unit constantly controls rod position and movement, intervening as soon as a faulty situation
is detected.
The FAILSAFE function makes it possible to detect any faults in the operation of the photocells.
The main operating modes and functions are set by a dip-switch, whereas the adjustment of work and pause times is done by self learning
during programming.
2. TECHNICAL SPECIFICATIONS
Power supply voltage 230 V~ (+6% -10%) 50 Hz / 115 V~ 60 Hz
Supply voltage of control unit 24 V~ nominal
a
Absorbed power 3 W
Motor nominal power 48 W
Accessories max. load 500 mA
Flashing lamp max. load 15 W
Max. load for beam lights 15 W
Max. load for courtesy light/indicator light 5 W
Operating ambient temperature -20°C +55°C
Protective fuse F1=8 A F2=500 mA F3=630 mA (resettable)
Function logics Automatic - Condo - Manual
Opening / closing time Through self-learning during programming
Pause time Through self-learning during programming
Obstacle detection Trimmer-adjustable
Selectable functions
Type of logic - Operation of open command - No mains power supplied
function - Beam lights flashing - Safety devices behaviour
Terminal board inputs
Power supply - Earth - Close - Open - Open/Close - Stop - Safety
devices - FAILSAFE
Inputs with connector Battery kit - Radio connector
Terminal board outputs
Power supply for accessories - On beam lights - Indicator light - Flash-
light
Board dimensions 79 x 158 mm
Characteristics of optional batteries See kit on price list
a
According to mains voltage, there may be different output values on the board power feed terminals. Before putting into
service, always check if the output voltage on the secondary winding of the transformer is from 20 V~ to 26 V~. Voltage
must always be measured load free.
3. PREPARATIONS
To ensure people’s safety, all warnings and instructions in this booklet must be carefully observed. Incorrect installation
or incorrect use of the product could cause serious harm to people.
Make sure that an adequate differential switch is installed upstream of the system as specified by current regulations.
On the main power supply, install a thermal breaker with omnipolar switching.
Make sure that an adequate earthing system is available.
To lay cables, use adequate rigid and/or flexible tubes.
Always separate the connecting cables of low voltage accessories from those supplying 230/115 V~, using separate sheaths to avoid
possible interference.
4. BOARD LAY-OUT (Fig. 1)
COMPONENTS COMPONENTS
CN1 Power supply terminal-board P OPEN/CLOSE channel memory storage push-button
CN2 Commands terminal-board F1 Board protection fuse
JP2 Battery kit connector DL1 CLOSE contact LED
JP Connector for receiver module DL2 OPEN contact LED
JP4 Power supply to RH closing motor DL OPEN/CLOSE contact LED
JP5 Power supply to LH closing motor DL4 STOP contact LED
TR1 Trimmer for adjusting obstacle detection sensitivity DL5 Photocells status LED
P1 Programming push-button DL6 OPEN contact signalling LED
P2
OPEN channel memory storage push-button
DL7
OPEN/CLOSE contact signalling LED
•
•
•
•
•