FAAC E124, Быстрое руководство

Страница: 21 / 24

20
OPEN A
RADIO 2
DL17
OPEN B
OK
9
OK
9
MAX
20”
TX1 TX2
MAX
20”
TX...
1”
1”
RC/LC
> 5”
+
+
RADIO 1
DL16
RADIO 1
DL16
햲
햳
lampeggio · flash · clignotement
· Blinksignal · destello · knippert ·
ON OFF
·
OPEN A OPEN B
-
OPEN A
RADIO 2
DL17
OPEN B
MAX
20”
DS
> 5”
+
+
RADIO 1
DL16
햲 햳
-
OK
9
1”
lampeggio · flash · clignotement
· Blinksignal · destello · knippert ·
ON OFF
·
OPEN A OPEN B
RADIO 1
DL16
ENGLISH
MEMORISING DS RADIO CONTROLS
1. On the DS radio control, choose the desired ON - OFF combination of the 12 dip-switches.
2. Press and hold + (OPEN A programming) or - (OPEN B/CLOSE programming).
3. After keeping the button pressed for about 5 sec, the corresponding radio LED (DL11 or DL12) will begin to flash slowly for about 20 sec.
4. Release the button.
5. During radio LED flashing, press the button of the radio control you wish to program.
6. The corresponding LED on the board (DL11 or DL12) will go on steady for 1 second and then go off, indicating that memorisation has been
completed.
7. To add other different codes, repeat the procedure starting from point 1.
8. To add other radio controls with the same code, set the 12 dip-switches according to the same combination as the already memorised radio
control.
DELETING THE RADIO CONTROLS
This operation CANNOT be reversed. This will delete ALL the radio control codes memorised as both OPEN A and OPEN B/
CLOSE. The cancellation procedure is active only in gate status visualisation mode.
1. Press and hold -
-
.
2. After pressing for about 5 sec, the DL12 LED begins to flash slowly; after another 5 sec of slow flashing and holding, the LEDs DL11 and
DL12 begin flashing more rapidly (cancellation has started).
3. Once rapid flashing has stopped, LEDs DL11 and DL12 will go on steady, confirming the cancellation of all the radio codes (OPEN A and
OPEN B/CLOSE) from the board memory.
4. Release -
-
. The LEDs will go off, indicating correct cancellation.