HYDRAULIC HOSES & POWER CORDS
Feed and attach hydraulic hoses
On the driver’s side (pump side) drill
three
1” holes through the bottom of the truck bed using a hole-saw
.
Insert a
rubber grommet in each hole.
(Note Make sure to check under the truck for an open area before drilling.)
On the passenger side drill
two
1” holes and insert two
rubber grommets. Cut and discard the tie wraps secur-
ing the hose loops.
Feed the hoses down through the holes on the passenger side of the truck (one hose per hole) and pass them
under the truck bed, up through the two holes in the driver’s side that are the farthest from the tailgate and set
the ends next to the Pump Counter Balance Valve.
Remove the hose plugs with a 9/16 and a 1/2 inch open end wrenches.
Have a cloth or shop towel ready. Some fluid will drip out of the
hoses. Place the 9/16 wrench on the hose end and the 1/2 wrench on
the hose cap and turn in opposite directions.
19
