MOUNT THE FRAME TO THE WHEEL WELLS
Use the drill with a 5/16” bit and align the bit with the screw
holes in the side panel.
(Caution, on most trucks the holes
will be located above the tire height. Check the position of
the tire relative to the holes you are drilling into the wheel
well before proceeding.)
Drill three holes that pass through
the holes in the “L” Spacer. Repeat process on the other frame.
Count back one from the truck cab end or front end. The
second hole
is the first hole to drill through. If the “L” Spacer
was mounted correctly this hole will pass through the hole at
the apex of the “L” Spacer. Drill holes through the 2nd, 3rd
and 4th holes.
Now that the unit Arm Frames are secured to the Side Filler brackets undertake the
following steps to attach the frames to the truck wheel wells.
Set the Three Hole Wheel Well
Push the three 5/16 screws through the 3 Hole Bracket on the inside of the wheel well. Put a flat washer, lock washer
and 5/16 nut on each of the screws and with one person operating an impact on the inside of the truck bed and another
under the truck in the wheel well with the open end wrench, securely tighten each of the three screws. Note illustra-
tions below.
16
