Ezgo MPT 1000 48V, Руководство пользователя

Страница: 42 / 78

OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Page 36
Owner’s Guide
Example: If all of the following events occur...
a) the system senses that the accelerator pedal is depressed (power applied to motor)
b) the brake is engaged so as to prevent vehicle motion
the TruCourse Technology system will sense a stalled motor condition and remove power from the motor. When the brake
pedal is released, the car will roll backwards slightly before power is returned to the motor.
High Pedal Disable Feature
High pedal disable prevents undesired acceleration if the direction selector lever is changed, or the key is turned on while the
accelerator is depressed.
Diagnostic Mode Feature
Diagnostic mode eases troubleshooting.
In the unlikely event of certain electrical system failures, the TruCourse Technology controller will default to a mode that will
permit the vehicle to operate, but at a very reduced speed.
This feature allows the vehicle to be driven back to its storage facility where the problem can be diagnosed.
The controller can be put in diagnostic mode by the technician and the controller will report the failure mode.
Starting And Driving
To reduce the possibility of roll - back which could result in severe injury or vehicle damage,
do not release the service brake until motor has started.
All vehicles are equipped with an interlock system that disables the controller and prevents the vehicle from being operated or
towed while the charger is connected. Remove the charger plug from the vehicle receptacle and properly store the cable prior
to moving the vehicle.
To operate the vehicle:
• Apply the service brake, place the key in the key switch and turn it to the ‘ON’/’N’ position.
• Move the direction selector to the direction desired.
• Release the park brake by depressing the service brake pedal until the park brake releases.
• Slowly depress the accelerator pedal to start the motor.
• When the accelerator pedal is released, the motor controls the deceleration. To stop the vehicle more quickly,
depress the service brake pedal.
When the direction selector is in the reverse position, a warning signal will sound to indicate that the vehicle is ready to run in
reverse.
Starting Vehicle On A Hill
To reduce the possibility of roll-back which could result in severe injury or vehicle damage, do
not release the service brake until motor has started
.
NOTICE