Ezgo MPT 1000 48V, Руководство пользователя

Страница: 25 / 78

Owner’s Guide
Page 19
INTRODUCTION
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
1. Key Switch / Headlight Switch
To reduce the possibility of component damage, the vehicle must be stopped before moving the key switch/direction
selector.
Located on the dash panel, the key switch enables the electrical system of the vehicle to be turned on and off by turning the
key and the headlight is operated by turning the key switch beyond ON position. To prevent inadvertent operation of the
vehicle when left unattended, the key should be turned to the ‘OFF’ position and removed.
2. State of Charge Meter
The vehicle is equipped with a state of charge meter located in the dash panel below the speedometer. The state of charge
meter indicates the amount of usable power in the batteries. The state of charge meter shows the condition of the battery
pack with F indicating a full charge on the battery pack and E indicating the battery pack needs to be charged.
3. Direction Selector
To prevent loss of control, do not move vehicle direction selector while the vehicle is in
motion. Moving the selector will result in sudden slowing of the vehicle and the beeping of a
warning device.
Located on the dash panel, this switch permits the selection of either ‘F’ (forward), ‘R’ (reverse) or neutral (the position
between forward and reverse). Vehicle should be left in neutral when unattended
4. Accelerator Pedal
Unintentional movement of the accelerator pedal will release the park brake and may cause
the vehicle to move which could result in severe injury or death.
With the key switch ‘ON’, depressing the accelerator pedal starts the motor.When the pedal is released, the motor will stop.
To stop the vehicle more quickly, depress the service brake.If key switch is ‘ON’ and park brake is set, depressing the accel-
erator inadvertently will release the park brake and will cause the vehicle to move which could cause severe injury or death.
Depressing the accelerator pedal will release the park brake if it is engaged. This is a feature to assure the vehicle is not
driven with the park brake engaged.Depressing the accelerator pedal is not the preferred method of releasing the park
brake.
5. Brake and Park Brake
If the vehicle is equipped with factory installed custom accessories, some accessories remain operational with the key switch in the
‘OFF’ position.
The brake pedal incorporates a park brake feature. To engage the park brake, push down on the upper section of the pedal
until it locks in place. The park brake will release when the service brake pedal is depressed. Use the lower section of the
brake pedal to operate the service brake system.
6. Horn
The horn button is located on the driver’s side floorboard; depressing the button will sound the vehicle’s horn.
7. Rear View Mirror
The rear view mirror is a two-position mirror manually adjusted for day and nighttime conditions.Sun Top kit is required to
install rear view mirror.
8. Front Seats
The front seat is designed for two occupant on each side of the seat.