Ezgo EXPRESS L6 2012, Руководство по ремонту и обслуживанию техника

Страница: 14 / 202

Page A-2
Repair and Service Manual
B
GENERAL INFORMATION & ROUTINE MAINTANENCE
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Fig. 1 Initial Service Chart
ROUTINE MAINTENANCE
Some maintenance items must be serviced more frequently on
vehicles used under severe driving conditions.
This vehicle will give years of satisfactory service
provided it receives regular maintenance. Refer to the
Periodic Service Schedule for appropriate service inter-
vals (Ref. Fig. 4). Refer to Lubrication Point for
appropriate lubrication location (Ref. Fig. 2).
Fig. 2 Lubrication Points
Do not use more than three pumps of grease for each
grease fitting at any one time- Excess grease may
cause grease seals to fail or grease migration into
areas that could damage components.
Putting more than three pumps of grease in a grease fit-
ting could damage grease seals and cause premature
bearing failure.
REAR AXLE
The only maintenance required for the first five years is
the periodic inspection of the lubricant level. The rear
axle is provided with a lubricant level check/fill plug
located on the bottom of the differential. Unless leakage
is evident, the lubricant need to be only replaced after
five years. The procedure to follow for checking the rear
axle lubricant level is in the REAR AXLE section.
BRAKES
After the vehicle has been put into service, it is recom-
mended that the brakes be checked daily by performing
a brake test.
To prevent severe injury or death resulting
from operating a vehicle with improperly oper-
ating brake system, the braking system must
be properly maintained. All driving brake tests
must be done in a safe location with regard for
the safety of all personnel.
For information on conducting a brake test, refer to
BRAKES section.
TIRES
Tire condition should be inspected per the Periodic
Service Schedule. Inflation pressures should be
checked when the tires are cool. Be sure to reinstall
valve dust cap after checking or inflating. For additional
information, refer to WHEELS AND TIRES section.
LIGHT BULB REPLACEMENT
Refer to ELECTRICAL SYSTEM for information regard-
ing light bulb replacement.
VEHICLE CLEANING AND CARE
When pressure washing vehicle, do not use pressure in
excess of 700 psi (4826 kPa). To prevent cosmetic
damage, do not use any abrasive or reactive solvents
to clean plastic parts.
It is important that proper techniques and cleaning
materials be used. Using excessive water pressure may
ITEM SERVICE OPERATION
Batteries Charge batteries
Seats Remove protective plastic covering
Brakes Check operation and adjust if necessary
Establish acceptable stopping distance
Check hydraulic brake fluid level
Tires Check air pressure (see SPECIFICATIONS)
Portable Remove from vehicle and properly mount
Charger
NOTICE
Rack
Ball
Joint