Ezgo EXPRESS L6 2012, Руководство по ремонту и обслуживанию техника

Страница: 51 / 202

Page E-5
Repair and Service Manual
B
B
FRONT SUSPENSION AND STEERING
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
If completing a wheel bearing adjustment as part of
another procedure, tighten front wheels per WHEELS
AND TIRES section.
Wheel Alignment
Tool List Qty.
Tape Measure.............................................................. 1
Chalk ........................................................................... 1
Wrench, 9/16".............................................................. 1
Wrench, 3/4"................................................................ 1
Crowfoot Socket, 3/4”.................................................. 1
Torque Wrench, ft. lbs. ................................................ 1
Socket, 13 mm, ........................................................... 1
Ratchet ........................................................................ 1
Torque Wrench, in. lbs................................................. 1
Lift the front of the vehicle and support on jack stands as
per SAFETY section. Confirm the alignment of the front
springs. See “Front Spring Replacement” on page E - 8.
Rotate each wheel and scribe a chalk line around the
circumference of the tire at the center of the tread pat-
tern. Lower vehicle and, with tires in the straight ahead
position, roll it forward approximately five feet in order to
allow the tires to take their normal running position.
Measure the distance between the chalk lines at both
the front and rear of the tires (Ref Fig. 5). The measure-
ment taken at the front of the tires should be 0" - 1/8”
(0 - 3 mm) less than the rear.
Fig. 5 Wheel Alignment
To hold threaded tube while loosening jam nut, use a wrench
on the center, flat section of tube.
The tie rod has different threads on each end. The end with
the flat area on the threaded tube has left hand threads (clock-
wise to loosen) while the end
without the flat has conventional
right hand threads (counter-clockwise to loosen).
To adjust wheel alignment, loosen tie rod jam nuts (1)
and turn tie rod (2) until correct alignment is achieved.
Tighten jam nuts to 36 - 40 ft. lbs. (49 - 54 Nm) torque.
Test drive vehicle and confirm steering wheel is correctly
centered. If it is not centered, disconnect intermediate
shaft from steering shaft and center steering wheel (Ref
Fig. 6). Reconnect intermediate shaft and tighten bolt to
155 - 215 in. lbs. (18 - 24 Nm) torque.
Fig. 6 Disconnect Intermediate Shaft to Center
Steering Wheel
X
Rear
X
Front
1/8" (3 mm)
0" (0 mm)
-
+
View from Underside
of Vehicle
Front of Vehicle
1
1 2
NOTICE
Intermediate
Shaft
Remove Bolt