Eytron TV8911, Руководство по установке

Страница: 61 / 162

27
RELAY OUTPUT SETUP
You can use the relay output to switch external equipment following an event.
For example, you can set off a siren following motion detection.
R E L A Y O U T P U T S E T U P
7
-
3
R E L A Y O U T P U T : O N
P E R I O D
V I D E O L O S S : O N 0 6 S E C
A L A R M : O N 0 6 S E C
M O T I O N D E T E C T I O N : O F F 0 6 S E C
[ D E F A U L T ]
Possible switching modes are NO (Normally Open) and NC (Normally Closed):
NO: the relay is open in normal state.
NC: the relay is closed in normal state.
The relay changes the state from open to closed or vice versa for a programmable time (1–60
seconds).
ƒ
RELAY OUTPUT: Switches the relay output ON/OFF. If the setting is OFF, the following
settings are ignored.
ƒ
VIDEO LOSS:
o
Sets a reaction of the relay at signal loss ON/OFF.
o
Duration in seconds of relay state change following signal loss.
ƒ
ALARM:
o
Sets a reaction of the relay on alarm ON/OFF.
o
Duration in seconds of relay state change following alarm.
ƒ
MOTION DETECTION:
o
Sets a reaction of the relay at motion detection ON/OFF.
o
Duration in seconds of relay state change following motion detection.
ƒ
DEFAULT: Restores the default values for relay output.