Eyevis EC-LED-SLIM Series, Руководство пользователя

Страница: 21 / 60

Status LED
Fig. 6: LEDs - display status
1
Power state
The power state LED indicates whether power circuit on the board is
“online”, that means whether the CPU is powered by 5V standby voltage.
2 Signal state
The signal state LED indicates the status of the video signal. If the video
signal is connected and valid, the LED lights up green.
3
CPU state
The CPU state LED indicates the status of the firmware. Following states
are possible:
x
Fast blinking (100 ms): CPU initialises
x
Slow blinking (500 ms): CPU is ready
x
Off: firmware has crashed
4 Error State
The error state LED indicates the error status. During the initialization
procedure the LED will blink together with the CPU state LED in the
same frequency. After the initialization the LED should be off.
Address (ID) switch
1
3 2
Fig. 7: Rotation-Switches
1 Left switch (for value x 100)
2 Central switch (for value x 10)
3
Right switch (for value x 1)
) NOTE
If you setup a cube video wall with wall mount installation and front access
option, the ID of the projectors must be adjusted at first.
Standby button
Fig. 8: Rotation-Switches with Standby
Button
1
Standby button
Sets the projector in power save mode. Reactivation through pressing
the button or over serial connection.
1
EC-LED-SLIM Series 21
Version 1.2 | October 2018