ExxtraSetter
Maxxima 300
OPERATOR'S MANUAL
3
film is affected by relatively small changes in humidity. This may affect the registration of successive
film separations.
♦
Low humidity also contributes to problems related to
static electricity
, such as film jams, improper
film feeding, and certain undesirable artifacts on developed film.
1.4 Initial Imagesetter Setup
1.
Locate the imagesetter in a place that meets the requirements outlined in
Section 1.3
.
2.
Install the main line cord into the receptacle in the back of the imagesetter and into the wall socket.
(Machines supplied for installation in North America come with the appropriate line cord. Because
of all the different types of main power receptacles throughout the world, units shipped outside of
North America require the user or equipment dealer to supply the correct line cord. The cord must be
compatible with the IEC320 receptacle on the back of the imagesetter and should be shielded).
3.
Attach the interface cable (not supplied with imagesetter, but usually supplied with the RIP interface
card) from the 50 pin ‘D’ connector on the back of the imagesetter to the interface card in the host
computer. See instructions supplied with the interface card for more information.
4.
Follow manufacturer's and/or integrator's instructions for setup and interconnection of the interface
card, host computer and the
RIP
.
5. Turn the imagesetter
ON
using the switch located next to the line cord receptacle.
6. See
Chaper 5 — Basic Operating Procedures
for film loading and calibration information.
