extronics iWAP200, Инструкция по установке и эксплуатации

Страница: 5 / 23

Operating Manual
5
2 Safety Information and Notes
2.1 Storage of this Manual
Keep this user manual safe and in the vicinity of the device. All persons who have to work on
or with the device should be advised on where the manual is stored.
2.2 ATEX Special Conditions of Safe Use
No special conditions of safe use are listed in the ATEX certificate
List of Notes
The notes supplied in this chapter provide information on the following.
•
Danger / Warning.
o
Possible hazard to life or health.
•
Caution
o
Possible damage to property.
•
Important
o
Possible damage to enclosure, device or associated equipment.
•
Information
o
Notes on the optimum use of the device
Warning Installation to be by skilled electricians and instructed personnel in
accordance with national legislation, including the relevant standards
and, where applicable, in accordance with IEC 79.17 on electrical
apparatus for explosive atmospheres.
Warning
For the installation, maintenance and cleaning of the units, it is
absolutely necessary to observe the applicable regulations and
provisions concerned with explosion protection (EN60079-0, EN 60079-
14) as well as the Accident Prevention Regulations.
Warning
The iWAP200 must NOT be operated in ATEX Zone 0/20 or Zone 1/21
hazardous areas. Refer to the declaration of conformity for ATEX
certificate information.
Warning Do not exceed the Effective Isotropic Radiated Power (EIRP) for the gas
group in which the iWAP200 will be operating. The RF output of the
transceiver will vary depending on the hardware and antenna used. The
maximum hardware limit of the access point must be used to calculate
the EIRP
– software control by the user of the RF power is not allowed
IIC
– 2W (+33dBm)
IIB – 3.5W (+35.4dBm)
IIA – 6W (+37.7dBm)
Warning
The iWAP200 MUST be earthed.