extronics iWAP200, Инструкция по установке и эксплуатации

Страница: 10 / 23

Operating Manual
10
Caution Only ever make one Ethernet cable to either the RJ45 connector or
Ethernet screw terminals
– NEVER both.
Diagram 3.1.3.1 – Mains Variant & PoE iWAP200 PCB
Connector Description Notes
110/230VAC
input These screw terminals allow the connection of a
110/230VAC power supply. Pinouts are; 1 = Live, 2 =
Neutral, 3 = Earth. If AC powered, no PoE is
required.
Do not apply AC voltage if
powering with PoE
Chassis Earth There are two terminals which allow a connection to
earth. When the iWAP200 is delivered one of these
terminals will be connected to the enclosure. The
second earth terminal spare.
Ethernet & PoE
Input (Terminals) Connect a Cat-5 cable to these screw terminals for
the connection of the Ethernet input. The pinouts on
this terminal correspond with the standard cat-5
TIA/EIA-568-B T568B wiring methods.
Only one Ethernet input
should be made, only use
either the terminals or RJ45
connector
NOT both.
Ethernet & PoE
Input (RJ45) This allows the connection of a standard Cat-5 cable
with plugs. Only one Ethernet input
should be made, only use
either the terminals or RJ45
connector
NOT both.
Fibre Input Allows a fibre connection to be made to the iWAP200
board. The connector will be a ST connector for
multimode fibre input, or a SC connector for single
mode fibre The copper Ethernet input is
disabled if the fibre module
is fitted
Table 3.1.3.2 – iWAP200 Mains / PoE Variant Pinouts
Ethernet & PoE
Input (RJ45) Ethernet & PoE
Input
(Screw Terminals)
Chassis
Earth 110/230VAC
Input
L N E
Fibre input
Tx Rx