Extron electronics XTP T USW 103, Руководство пользователя

Страница: 21 / 46

XTP T USW 103 Switcher • Installation 13
Remote power
The XTP T USW 103 can be powered remotely through an XTP Power Injector or through
an XTP matrix switcher.
ATTENTION:
• XTP remote power is intended for indoor use only. No part of the network that uses
XTP remote power should be routed outdoors.
•
XTP à distance est destiné à une utilisation en intérieur seulement. Aucune partie
du réseau qui utilise l’alimentation XTP à distance ne peut être routée en extérieur.
Power injector
To power the XTP T USW 103 remotely with an XTP Power Injector, power a connected
receiver locally (see
Local power on page 11) and connect an XTP Power Injector to the
XTP cable run along the XTP ports (see the XTP Power Injector User Guide at
www.extron.com for more installation information).
POWER
12V
2
1.0 A MAX
G
1
SIG LINK
XTP OUT LAN
AUDIO
RGB HDMI HDMI
CONTACT
Rx G G Tx
RS-232 IR
Rx Tx
RS-232
Tx Rx
3
1 2 3
R
OVER XTP REMOTE
INPUTS
LAN
SIG LINK
XTP IN
POWER
12V
HDMI
1A MAX
Rx G Tx
RS-232 IR
Rx Tx
− + − +
L R 1 2
OVER XTP
AUDIO
OFF
ON
S/PDIF
RESET
XTP R HDMI
RELAYS OUTPUTS
AUDIO
XTP
PWR
XTP PWR
100-240V 50/60 Hz
---A MAX Power
Extron
XTP R HDMI
XTP Receiver
Extron
XTP PI 100
XTP Power
Injector
Shielded Twisted
Pair Cable
Remote
Power
12V Local Power
Supply
Extron
XTP T USW 103
XTP Transmitter
Figure 10. Typical Point-to-Point Application with Remote Power
NOTE: The power injector provides remote power up to 330 feet with a shielded twisted
pair cable with 24 AWG wire.
XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power to
connected XTP devices (see the XTP matrix switcher user guide at
www.extron.com for
more details). To manage available power from the XTP matrix switcher, use the XTP System
Configuration Software with the matrix switcher.