Extron electronics XTP T USW 103, Руководство пользователя

Страница: 15 / 46

XTP T USW 103 Switcher • Installation 7
H
Remote RS-232 connector — Connect a host device to the 3.5 mm, 3-pole captive
screw connector (see figure 2 ,
H
on page 4) for serial control of the switcher.
Do not tin the wires!
Controlling
Device
Ground (G)
Receive (Rx)
Transmit (Tx)
Ground (G)
Receive (Rx)
Transmit (Tx)
Bidirectional
Tx Rx G
RS-232
Figure 4. Remote RS-232 Wiring
I Power connector and LED — Connect the external 12 V, 1.0 A power supply to
the 2-pole captive screw connector (see figure 2 ,
I
on page 4). For wiring
considerations, see Power Connection on page 11. The Power LED lights to
indicate the device is receiving power.
NOTE: The XTP T USW 103 can also be powered remotely (see
Remote power
on page 13).
Connection Details
HDMI Connection
To secure the HDMI cable to the HDMI input connector, use an Extron LockIt Cable Lacing
Bracket and a tie wrap.
3
1
2
3
4
5
Figure 5. Installing the LockIt Cable Lacing Bracket
1. Plug the HDMI cable into the panel connection (see figure 5,
1
).
2.
Loosen the HDMI connection mounting screw from the panel (
2
) enough to allow the
LockIt to be placed over it. The screw does not have to be removed.
3. Place the LockIt on the screw and against the HDMI connector (
3
), and then tighten
the screw to secure the bracket.
4. Loosely place the included tie wrap around the HDMI connector and the LockIt (
4
).
5. While holding the connector securely against the cable lacing bracket, use pliers or
similar tools to tighten the tie wrap, then remove any excess length (
5
).
ATTENTION:
• Connect and pull the tie wraps until they are secure. Do not overtighten.
• Connectez et tirez les serre-câbles jusqu’à ce qu’ils soient sécurisés. Ne pas
trop serrer.