XTP SR HDMI Scaling Receiver • Operation
22
Front Panel Lockout Mode (Executive Mode)
Front Panel Lockout (Executive) mode locks all front panel controls (RS-232 and USB
control are still available). To enable or disable executive mode through the front panel,
press and hold the
Menu
and
Enter
buttons simultaneously for about 2 seconds or until the
Power LED blinks (see
Front Panel Lockout (executive) mode
SIS commands on
page 30 or
XTP System Configuration Software
on page 32 for remote enabling or
disabling of executive mode).
Reset Mode
Use the recessed
Reset
button on the rear panel of the transmitter or receiver (see
figure 17,
A
) to restore factory-shipped firmware.
LAN
SIG LINK
XTP IN
POWER
12V
HDMI
1.0 A MAX
Rx G
Tx
RS-232
IR
Rx
Tx
−
+
−
+
L
R
1
2
OVER XTP
AUDIO
OFF
ON
S/PDIF
RESET
RS-232
Tx Rx G
REMOTE
RELAYS
OUTPUTS
AUDIO
A
Figure 17.
Rear Panel Reset Button
Reset Mode Summary
Mode
Mode Activation
Result
Purpose and Notes
Factory
Reset
1
Hold down the recessed
Reset
button while applying power to the
device.
NOTE:
After a mode 1 reset,
update the device with the
latest firmware version. DO
NOT operate the firmware
version that results from this
mode reset.
The device reverts to the factory
default firmware.
NOTE:
If you do not want
to update the firmware or
perform a mode 1 reset by
mistake, cycle power to
the device to return to the
firmware version running prior
to the reset.
Use mode 1 to return
to factory firmware for
a single power cycle if
an incompatibility issue
arises.
