XTP R HWP 201 Wallplate Receiver • Installation
6
Mud Ring Installation
Backing Clip
Mounting Screw
Rotate the backing clip
out of the way to insert
the mud ring into the wall.
Figure 2.
Installing the Mud Ring with Backing Clips
1.
Place 1.25 inches (3.18 cm) long or 0.75 inch (1.90 cm) #6-32 thread machine screws
through the large holes in the two corners of the mounting bracket. Use the shortest
possible screw needed.
2.
Loosely fasten the mounting backing clip on the end of each screw.
3.
Insert the mounting bracket into the opening in the wall (see
Mounting Surface
Preparation
on the previous page).
4.
Rotate each backing clip so that the tab is behind the installation surface to hold the
bracket snuggly in place when the screw is tightened.
NOTE:
The backing clip can be installed as shown in Layout A or Layout B (see
figure 3).
Layout A
0.75" #6-32 Screw
Backing Clip
Backing Clip
Mounting Surface
Mounting Surface
Layout B
1.25" #6-32 Screw
Figure 3.
Backing Clip Installation
5.
Use a cross-head (Phillips) screwdriver to fasten the screws and backing clips in place.
