Extron electronics TLP 710MV, Руководство пользователя, Страница: 53 / 54

Reset Modes
The TLP 710MV and TLP 710TV have four reset modes that correspond to four of the
five reset modes for the IP Link controllers. The modes are initiated by pressing the Reset
button.
To access the Reset button on the TLP 710MV, remove the bezel. See page 5 to locate the
Reset button on the TLP 710MV . The Reset button on the TLP 710TV is on the back
panel. See page 10 to locate the Reset button on the TLP 710TV .
TLP 710 MV and TLP 710TV Reset Mode Summary
Mode Activation Result Purpose and Notes
Use Factory Firmwar
e
1 Hold down the recessed Reset button
while applying power to the TLP 710.
NOTE: After a mode 1 reset is
performed, update the TLP 710
firmware to the latest version.
Do not operate the firmware
version that results from this
mode reset. To use the factory
default firmware, reload that
version. See page 21 for details
about uploading firmware.
The TLP 710 reverts to the factory default
firmware.
Event scripting does not start if the TLP
710 is powered on in this mode. All user files and
settings (drivers, adjustments, IP settings, etc.) are
maintained.
NOTE: If you do not want to update firmware
or you performed a mode 1 reset by
mistake, cycle power to the TLP 710 to
return to the firmware version that was
running before the mode 1 reset. Use the
0Q SIS command to confirm that the factory
default firmware is no longer running (look
for asterisks following the version number).
This mode reverts to the
factory default firmware
version if incompatibility
issues arise with
user-loaded firmware.
NOTE: User-defined
web pages may
not work correctly
with an earlier
version of the
firmware.
Run or Stop
Events
3 Hold down the Reset button for
approximately 3 seconds until the
Release LED blinks once. Then release
and press Reset momentarily (less than
1 second) within 1 second.
This mode turns events on or off.
NOTE: Nothing happens if the momentary
press does not occur within 1 second.
This mode is useful for
troubleshooting.
Reset all IP
Settings
4 Hold down the Reset button for
approximately 6 seconds until the
Release LED blinks twice (at 3 seconds
and 6 seconds). Then release and
press Reset momentarily (less than
1 second) within 1 second.
NOTE:
Nothing happens if the
momentary press does not
occur within 1 second.
This mode:
•
Enables ARP capability.
•
Resets the IP address to the factory default
(192.168.254.254).
•
Resets the subnet to the factory default.
•
Resets the gateway address to the factory
default.
•
Resets port mapping to the factory default.
•
Turns DHCP off.
•
Turns events off.
This mode enables
you to set IP address
information, using ARP
and the MAC address.
Reset to
Factory
Defaults
5
Hold down the Reset button for
approximately 9 seconds until the
Release LED blinks three times (at 3,
6, and 9 seconds). Then release and
press Reset momentarily (less than
1 second) within 1 second.
NOTE:
Nothing happens if the
momentary press does not
occur within 1 second.
This mode performs a complete reset to factory
defaults (except the firmware). It does everything
that mode 4 does and, in addition:
•
Removes button and touchpanel
configurations.
•
Resets all IP options
•
Removes all scheduling options.
•
Removes and clears all files from the TLP 710.
This mode is useful
to start over with
configuration and
uploading. It also allows
you to replace events.
TLP 710MV and TLP 710TV • Reset Modes 47