k
Power connector
— Connect the 2-pole, 3.5 mm captive screw connector from the
12 VDC, 1.0 A power supply (not provided) to the power supply socket on the rear
panel. Ensure the connections have the correct polarity as shown in figure 10.
NOTES:
• Extron recommends using the Power over Ethernet power supply.
This 12 VDC, 1.0 A power supply should only be used for setup or
troubleshooting.
•
If both power supplies are connected to the TLP 710TV, the PoE power
supply takes precedence.
Power Receptacle
DC Power Cord
Captive Screw Connector
AC Power Cord
Ground
+12 VDC
External
Power Supply
(12 VDC, 1 A )
SECTION A–A
Ridges
Smooth
Power Supply
Output Cord
A
A
3/16"
(5 mm) Max.
Figure 10.
Power Supply Connection
CAUTION:
See the
cautions
on page 7 for important information about power
supplies.
NOTE:
See the
notes
on page 7 for important information about wiring captive
screw connectors.
l
MTP signal adjustments
— Three MTP signal adjustments are available for S-video
luminance gain (VID/Y), S-video chrominance gain (C), and sharpness (S). For
composite video signals, the gain is controlled by the VID/Y adjustment. Insert a small
Phillips head screwdriver into the recess and turn clockwise (to increase adjustment) or
counterclockwise (to decrease).
m
MTP input
— A twisted pair cable, terminated with an RJ-45 connector, provides
video and audio input from an Extron MTP transmitter. The MTP port is in the top
surface of the recessed area (see the arrow to the left in
figure 9
).
CAUTION:
Connect the MTP transmitter to the MTP socket and the network
connector to the network socket. Although both use RJ-45
connectors, the MTP socket (on the left) must be connected to an
MTP transmitter and the network socket (on the right) must be
connected to a LAN. The wires on each connector use different
voltages and inputting the wrong voltages into a socket will damage
the TLP 710TV.
TLP 710MV and TLP 710TV • Panel Features
11
Содержание TLP 710MV
Страница 6: ...TLP 710MV and TLP 710TV Contents vi ...