Extron • SENTOSA
xi
LQ & LANCIA
xi
LD • User’s Manual
Switch Settings
The switches on the DIP switch module used in the
Sentosa
xi
/Lancia
xi
are the “rocker” type (see end view
drawing, below-right). The primary difference between
the rocker type and the “slide” type (which could also
be used) is the action required to change the position
of the switch. To change the position of the rocker type
switch, press down against the desired end (enable or
disable) with a pointed object. To change the position
of the slide switch, a small screwdriver is used to push
(slide) the switch to the desired position (enable/on or
disable/off).
Set the DIP Switches, located on the rear panel of the
Sentosa
xi
/Lancia
xi
, as required. The right side of the
switch module is the enable position. (See DIP switch
descriptions beginning at the bottom of this page.)
Sentosa
xi
Rear Panel
Lancia
xi
Rear Panel
Select the desired sync type using the H/HV/SOG toggle switch
(located between the H/HV and V BNC connectors – see rear
panel drawings above). Switch positions are:
Top (H) = Horizontal sync on H/HV BNC, Vertical sync on V BNC
Center (HV) = Composite HV sync on H/HV BNC
Bottom (SOG) = Sync on Green BNC
DIP Switch Module (Sentosa
xi
xixi
xixi
and Lancia
xi
xixi
xixi
)
The function of each DIP switch follows. The switches on the DIP
Switch module are numbered 1 – 8 from top to bottom.
#1 – AUTO SW (Auto Switch Mode)
Disabled – Input selection is a manual operation through the
front panel input selection switch or through the
RS-232/Contact REMOTE connector.
Enabled – The input with video present will be selected
automatically. Input 2 has priority (If video is
present on both connectors, Input 2 will be
selected.)
Installation and Operation
Page 2-3
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
