Extron • SENTOSA
xi
LQ & LANCIA
xi
LD • User’s Manual
Front and Rear Panels (Sentosa
xi
xixi
xixi
and Lancia
xi
xixi
xixi
)
Front and rear panel component descriptions follow.
Front Panel
The letters next to the following descriptions match circled letters
in the drawing below. Descriptions apply to Sentosa
xi
& Lancia
xi.
A
Power LED – If the LED is on, power is on. If AC voltage is
available to the device, power will be on. When power is initially
applied, all front panel LEDs flash to indicate power up OK.
B
Input Selection Push Button Switch – Select Input 1 (composite
video) or Input 2 (S-Video).
C
Input 1 LED – Composite video is selected if this LED is on.
D
Input 2 LED – S-Video is selected if this LED is on.
E
Freeze Push Button Switch – Selects Freeze Frame or Motion
mode (toggles between the two).
F
Freeze LED – Freeze Frame Mode is active if this LED is on. While
in this mode, the output will be a single frame of video until the
Freeze button is pressed.
_ The Color, Tint, Contrast and H Shift Controls described below are
the continuous turning type – they have no mechanical limits. When
the minimum or maximum limit is reached, the MIN or MAX LED will
blink*. MIN and MAX LEDs both blink once when the control passes
through the default value. Rotation of a control will increase or
decrease a decimal value which is stored in a nonvolatile memory.
The memory stores two sets of decimal values, one set for each
input. Each set includes the current values for the four controls.
G
Color – Color intensity adjustment control.
H
Tint** – Tint (Hue) adjustment control.
I
Contrast – Contrast and Brightness control.
J
H Shift – Screen image horizontal centering control.
_ To reset the Color, Tint, Contrast and Horizontal Shift values press
and hold the Freeze button during power-up. Values for the current
input will reset to the factory default settings.
K
MIN LED* – Minimum limit reached if blinking and MAX LED OFF.
L
MAX LED* – Maximum limit reached if blinking and MIN LED OFF.
* – MIN or MAX LEDs blink when rotation of a control continues after
its value has reached a limit.
There is no indication of a value at a
limit unless its control is rotated. MIN and MAX LEDs ON together
indicate X Mode and the controls are locked out (see #8, page 2-4).
**
If a control does not apply to the video type in use, the MIN and
MAX LEDs both blink continuously while the control is being rotated
(for example, rotating the Tint control with PAL video input).
1
2
Installation and Operation
Page 2-5
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
