IN1604 DTP and IN1604 HD Scalers • Installation
10
HDMI Connections
Use an Extron LockIt lacing bracket to secure an HDMI cable to each device.
1.
Plug the HDMI cables into the panel connection (see
1
of the image below and to
the right).
2.
Loosen the side HDMI connection mounting screw
from the panel enough to allow the LockIt lacing
bracket to be placed over it (see
2
). The screw
does not have to be removed.
3.
Place the LockIt lacing bracket on the screw and
against the HDMI connector, then tighten the screw
to secure the bracket (see
3
).
ATTENTION:
Do not overtighten the HDMI
connector mounting screw. The shield to
which it is fastened is very thin and can easily
be stripped.
ATTENTION :
Ne serrez pas trop la vis de
montage du connecteur HDMI. Le blindage
auquel elle est attachée est très fin et peut
facilement être dénudé.
4.
Loosely place the included tie wrap around the HDMI connector and the LockIt
lacing bracket (see
4
).
5.
While holding the connector securely against the lacing bracket, use pliers or a
similar tool to tighten the tie wrap, then remove any excess length.
The LockIt bracket can also be used in a stacked formation, as shown below.
Side Mounted
Stacked
Figure 6.
LockIt Bracket Mounting Options
1
2
3
4
