IN1604 DTP and IN1604 HD Scalers • Installation
7
A
Power connector
— Connect the standard IEC power cord from a 100 to 240 VAC,
50-60 Hz power source into this connector. The front panel control and input selection
buttons light in sequence during power-up.
B
Analog video connector
— Connect a video source to the 15-pin HD connector. It
accepts RGB, YUV, S-video, and composite video (see
Analog Video Wiring
on
page 9).
C
HDMI input connectors
— Connect video sources to the HDMI connectors.
TIP:
Use Extron HDMI LockIt Lacing Brackets to secure HDMI cables to the device
(see
HDMI Connections
on page 10).
D
Analog audio input connector
— Connect an audio source to the 3.5 mm
tip-ring-sleeve (TRS) connector for unbalanced analog audio.
Tip (+)
Sleeve ( )
Sleeve ( )
Ring (-)
Tip (+)
Audio Plugs.eps
RCA Connector
3.5 mm Stereo Plug Connector
(balanced)
Sleeve ( )
Ring (R)
Tip (L)
3.5 mm Stereo Plug Connector
(unbalanced)
Figure 3.
TRS Wiring
E
Analog audio input connector
— Connect an audio source to the 5-pole captive
screw connector. Wire the connector for line level, balanced or unbalanced, analog
stereo.
Unbalanced Audio Input
Balanced Audio Input
Tip
Ring
Tip
Ring
Sleeves
Tip
Sleeve
Sleeve
Tip
LR
LR
Do not tin the wires!
Figure 4.
Audio Input Connector Wiring
F
Analog audio output connector
— Connect audio output devices to this 5-pole
captive screw connector. Wire the connector for line level, balanced or unbalanced,
analog stereo.
Do not tin the wires!
Balanced Audio Output
Tip
Ring
Tip
Ring
Sleeves
Unbalanced Audio Output
Tip
No Ground Here
No Ground Here
Tip
Sleeves
LR
LR
Figure 5.
Audio Output Connector Wiring
G
TP output connector and TP output switch (IN1604 DTP only)
— Connect a DTP
receiver or HDBaseT-enabled device to the TP output RJ-45 connector to send all
signals over a single twisted pair cable (see
Twisted Pair Recommendations for DTP
Communication
on page 11 for wiring and cable recommendations).
Use the recessed switch to the right of the connector to set the signal type to the
type of receiver connected to the TP output connector. Position the switch Up to
send HDBaseT signals. Position the switch Down to send DTP signals.
ATTENTION:
Position this switch BEFORE connecting the appropriate device to
the TP connector. Failure to comply can damage the endpoint.
ATTENTION :
Positionnez ce interrupteur AVANT d’alimenter le point de connexion
connecté. Ne pas respecter cela pourrait endommager le point de connexion.
HDBT
DTP
