FOX 500 Tx/Rx • Remote Control
Remote Control, cont’d
4-20
FOX 500 Tx/Rx • Remote Control
4-21
N
When you make horizontal or vertical position changes
(shift the image), the setting is changed in the receiver. It
reports the shift values to the transmitter via the optional
Optical 2 cable.
If you are connected to either of the transmitter's serial
ports, and the Optical 2 cable is not connected in your
system, you can still shift the image in the control
program's Video Adjustment area, but the program
cannot report the position values.
Output Configuration area
Sync Format radio buttons —
Click either the RGBHV/RGBS
or RGsB radio button to select the desired video output sync
format.
Output Polarity radio buttons —
Click either the
Follow input
sync or
Force sync to negative
radio button to select the desired
video output sync polarity.
N
When you make output configuration changes, the setting
is changed in the receiver. It reports the changes to the
transmitter via the optional Optical 2 cable.
If you are connected to either of the transmitter's serial
ports, and the Optical 2 cable is not connected in your
system, the program cannot report the output sync format
and polarity position settings in the control program's
Video Adjustment area. You can change the output sync
format and polarity, but the program cannot report the
changes.
Advanced Configuration area
Executive Mode button —
Click the Executive Mode radio
button to toggle the front panel lock on and off.
N
When you toggle the front panel lock on and off, the setting
is changed in the receiver. It reports the changes to the
transmitter via the optional Optical 2 cable.
If you are connected to either of the transmitter's serial
ports, and the Optical 2 cable is not connected in your
system, you can still toggle the front panel lock in the
control program's Advanced Configuration area, but the
program cannot report the lock's status. The program
indication changes (figure 4-6) to show that the Executive
mode is control only, without and indication of the current
mode. The
Set executive mode On
or
Off
message is
displayed for approximately 1 second.
Figure 4-6 — Alternate Advanced Configuration area
indication
Auto Memory checkbox —
Click the Auto Memory checkbox
to automatically apply saved position, horizontal start,
total pixels, and pixel phase settings when the sensed input
resolution changes. See "Auto Memory submenu" in chapter 3,
"Operation" for more details about the auto memory function.
Auto Image button —
Click the Auto Image button to adjust
the output settings for the best image, based on the sensed input
resolution.
Test Patterns drop box —
Select one of three built-in test
patterns; Color Bars, grayscale, and alternating pixels; as
necessary to help adjust the display's color, focus, and grayscale.
Select Off to output the video input to the transmitter.
N
You must have a video input connected and fiber cable
Optical 1 connected between the transmitter and receiver
for the receiver to output a selected test pattern.
The test pattern will turn off if the input signal rate is
changed or disconnected or if power is removed.
Audio Adjustment area
Audio Gain/Attenuation slider —
Click and drag the Audio
Gain/Attenuation slider control to select the input audio gain or
attenuation value, from -18 dB to +10 dB in 1.0 dB increments.
N
When you make input gain or attenuation changes, the
setting is changed in the transmitter.
If you are connected to either of the receiver's serial ports,
and the Optical 2 cable is not connected in your system,
you cannot change the input value from the control
program's Audio Adjustment area.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
