FOX 500 Tx/Rx • Operation
Operation, cont’d
3-10
FOX 500 Tx/Rx • Operation
3-11
Auto Image Trigger submenu
The auto image function adjusts the output settings for the best
image, based on the sensed input resolution.
Rotate either adjust knob to trigger the auto image function.
N
If no video input is connected, the submenu display reads
Auto Image N/A and no function is available from this
screen.
Pattern submenu
The receiver can output any of three test patterns that help you
adjust the display's color, focus, and grayscale. Rotate either
Adjust knob while in the Pattern submenu to select among the
Color Bars, grayscale, and alternating pixels test patterns.
N
You must have a video input connected and fiber cable
Optical 1 connected between the transmitter and receiver
for the receiver to output a selected test pattern.
The test pattern will turn off if the input signal rate is
changed or disconnected or if power is removed.
The size of the test pattern depends on the size of the active
input signal. Any picture adjustments made on the input
affect the test patterns as well.
Exit menu
From the Exit menu (figure 3-8), press the Next button to return
to the default display cycle, or press the Menu button to return
to the Picture Control menu.
AUDIO
CONFIG
Menu
Menu
30 sec.
Menu
Menu
Menu
EXIT MENU
PRESS NEXT
OUTPUT
CONFIG
PICTURE
CONTROL
Menu
ADVANCED
CONFIG
Menu
Next
MEMORY
PRESETS
FOX 500
nn
.
n
k
nn
Hz
Figure 3-8 — Exit menu flowchart
System reset
To reset the FOX 500 to the factory default settings, press and
hold the Menu button while applying power. After about 3
seconds, the LCD displays System Reset message. Release the
Menu button.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
